|
2000 LINCOLN LS User Comment / Complaint
2007-11-07 Cambridge, OH
I am concerned with the safety of my lincoln. when the coils go bad the car starts missing. i was stopped being a school bus when my rpm's surged to 6500 and my car jolted forward. after the bus started up, i gave the car little gas to go, and it stalled. it stalled on the interstate the evening before. the mechanic told me that 3 coils were out. i have had the same situation 3 or 4 other times. my 2000 lincoln ls has had several coils replaced. mechanic finally determined that the valve cover gasket was bad. after replacing the gaskets, 3 coils went out within several days. i think that from my research, the valve cover gaskets are defective and should be recalled and coils replaced or reimbursement made for coils already replaced. i feel that this is a safety issue when the car surges and stalls on the highway.
view
2009-01-10 Knoxville, TN
I do not think it is your coils or valve cover gaskets. I had the same problem and replaced gaskets, all coils, and plugs. Still had the stalling and surging issue. I found the answer on a blog, not from the stealership. It is most likely a 3 inch hose connected to your pvc valve, it cant take the heat and a hole is burned into it and it causes the vehicle to stall. It costs about $9, but is about $300-$400 in labor. Hope this helps.
view
Keywords:
LINCOLN LS Comments and Complaints, Safety Comments and Complaints LINCOLN LS, LINCOLN LS Vehicle Safety Comments and Complaints, Comments and Complaints LINCOLN LS, LINCOLN LS Comments and Complaints, Vehicle Comments and Complaints LINCOLN LS, LINCOLN LS Comments and Complaints Vehicle Page Description: LINCOLN Comments and Complaints - Vehicle Safety Comments and Complaints Information for LINCOLN LS |
Report Abuse
SEND TO FRIEND
LEAVE COMMENT
I do not think it is your coils or valve cover gaskets. I had the same problem and replaced gaskets, all coils, and plugs. Still had the stalling and surging issue. I found the answer on a blog, not from the stealership. It is most likely a 3 inch hose connected to your pvc valve, it cant take the heat and a hole is burned into it and it causes the vehicle to stall. It costs about $9, but is about $300-$400 in labor. Hope this helps.